DVD Menu Options
Video Output
Choose the type of video output that
matches the connection of the DVD
Player to your TV.
- - VIDEO SETUP PAGE - -
TV STANDARD
TV DISPLAY
CLOSED CAPTIONS
VIDEO OUTPUT
PROGRESSIVE
SMART PICTURE
MAIN PAGE
S-VIDEO
YPbPr
RGB
1 Press 34 to highlight ‘Video Output’.
2 Enter its submenu by pressing 2.
3 Press 34 to choose a setting.
➜
S-Video: If you have connected the S-
Video Out jack to a TV.
➜
YPbPr: If you have connected the
YPbPr Out jacks to a TV.
➜
RGB: If you have connected the RGB
out jack to a TV.
4 Press OK, then press 1 to return to the
Video Setup Page.
Progressive
To select this item you must set ‘Video
Output’ to YPbPr (see left) and ensure
your TV has progressive scan.
- - VIDEO SETUP PAGE - -
TV STANDARD
TV DISPLAY
CLOSED CAPTIONS
VIDEO OUTPUT
PROGRESSIVE
SMART PICTURE
ON
OFF
1 Press 34 to highlight ‘Progressive’.
2 Enter its submenu by pressing 2.
3 Press 34 to choose a setting.
➜
On: Enable Progressive Scan video.
➜ Off: Disable Progressive Scan video.
4 Press OK, then press 1 to return to the
Video Setup Page.
Helpful Hint:
– If a blank/distorted TV screen appears,
wait for 15 seconds for auto recover.
–To deactivate the progressive function,
refer to the hint menu displayed on the TV
screen or see pages 15 and 16.
CANCEL
- - REFER TO THE OWNER'S MANUAL - -
Confirm again to use progressive scan
If picture is good, press OK button on remote control
OK
2 3 - Move OK - Select
To deactivate progressive:
1. Open tray,
2. Press '1' Key.
- - REFER TO THE OWNER'S MANUAL - -
ACTIVATING PROGRESSIVE:
1. Ensure your TV has progressive
2. Connect with YPbPr (GBR) video
3. If there is a blank screen on normal
wait 15 seconds for auto recover
CANCEL
OK
2 3 - Move OK - Select
To Next Page
Loading...
