Philips EasyClean - Product Setup and Preparation; Attaching the Brush Head

- The UV light bulb is hot during and immediately after the sanitising
cycle. Do not touch the UV light bulb when it is hot.
- Do not operate the sanitiser without the protective screen in place
to avoid contact with a hot bulb.
- If the sanitiser has been used for 3 consecutive UV clean cycles
(i.e. 3 times in a row), switch it off for at least 30 minutes before
ou start another UV clean cycle.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic elds.
General description (Fig. 1)
1 Hygienic travel cap
2 Brush head
3 Battery charge indicator
4 Power on/off button
5 Handle
6 Charger (specic types only)
7 UV sanitiser base with integrated charger and cord wrap
(specic types only)
- Not shown: UV light bulb
- Not shown: Sanitiser drip tray
- Not shown: Protective screen for UV light bulb
Note: The contents of the box vary based on the type purchased.
Preparing for use
Attaching the brush head
1 Align the front of the brush head with the front of the toothbrush
handle.
2 Push the brush head onto the metal shaft (Fig. 2).
Note: There is a small gap between the brush head and the handle.
ENGLISH8