Philips Efficia DFM100 - Disabling the EtCO2 Monitoring Function; Troubleshooting

9: Monitoring CO
2
Disabling the EtCO
2
Monitoring Function
108
Disabling the EtCO
2
Monitoring Function
To disable the EtCO
2
monitoring function, disconnect the sensor’s cable from the Efficia DFM100.
The message
 appears. Select  and press the Smart Select
knob.
Should the sensor and cable be disconnected accidentally, the message


appears to notify you of the disconnection. Select  and press the Smart Select knob.
Secure the connection. The CO
2
monitoring function is enabled again.
Troubleshooting
If your Efficia DFM100 does not operate as expected during CO
2
Monitoring, see Table 53 “EtCO
2
Problems” on page 190.