Philips Efficia DFM100 - Page 146

13: Data Management Event Summary
134
 Logged when the Efficia DFM100 is evaluating the ECG rhythm.


(with settings)
Initial ECG bandwidth for display, printing and storage are logged.
 Logged when the device detects a therapy equipment failure.
SpO
2
/ Logged when SpO
2
monitoring is connected and any subsequent
disconnect/connect.
 (value, limit) Logged when the patient’s SpO
2
value is higher than the configured limit.
 (value, limit) Logged when the patient’s SpO
2
value is lower than the configured limit.
 (value, limit) Logged when the patient’s Desat value is lower than the configured limit.
 Logged when the device is on and unable to acquire a Pleth waveform.
 Logged when SpO
2
monitoring is on and the sensor is disconnected.
 Logged when SpO
2
is on and a noisy signal is detected.
 Logged when SpO
2
is on and light interference is detected at the SpO
2
sensor.
 Logged when SpO
2
is on and a non-pulsatile SpO
2
sensor signal is detected.
 Logged when SpO
2
is on and an SpO
2
equipment malfunction is detected.
 Logged when SpO
2
is on and an erratic measurement condition occurs.
 Logged when SpO
2
is on and the SpO
2
measurement update period exceeds 30
seconds.
 Logged when SpO
2
is on and low perfusion occurs.
 Logged when a non-critical SpO
2
error is detected.
/

Logged when SpO
2
alarms are turned on or off and any subsequent change.
 (low) (high) 
(limit)
Logged when SpO
2
alarms are turned on and when there is a change in alarm limits.
Pulse
 (value, limit) Logged when the patient’s pulse is higher than the configured limit.
 (value)  (limit) Logged when the patient’s pulse is lower than the configured limit.
/

Logged when pulse alarms are turned on or off and any subsequent change.
 (low limit) (high
limit)
Logged when pulse alarms are turned on and when there is a change in alarm limits.
EtCO
2
/ Logged when EtCO
2
monitoring is connected and any subsequent
disconnect/connect.
 (value, limit) Logged when the patient’s EtCO
2
value is higher than the configured limit.
 (value, limit) Logged when the patient’s EtCO
2
value is lower than the configured limit.
(type) Logged when a CO
2
sensor is connected to the Efficia DFM100.
Table 29 Event Information (Continued)
Logged Event Frequency