Philips Efficia DFM100 - Internal Assemblies - Rear Case

Event Summary 13: Data Management
135
 Logged when the CO
2
sensor has not warmed up to operating temperature range.
 Logged when the CO
2
sensor is unplugged or the filter line is disconnected.
 Logged when the CO
2
sensor is unplugged.
/

Logged when CO
2
alarms are turned on or off and any subsequent change.
 (low value) (high
value)
Logged when CO
2
alarms are turned on and when there is a change in alarm limits.
 If using the Mainstream or Sidestream sensor, logged when the sensor is zeroing.
 If using the Mainstream or Sidestream sensor, logged when the sensor needs to be
zeroed.
 If using the Mainstream or Sidestream sensor, logged when the sensor zeroing is
complete.
(reason) If using the Mainstream or Sidestream sensor, logged when the sensor zeroing failed.
 Logged when the CO
2
sensor has reached its end of life.
 Logged when the CO
2
sensor needs servicing.
 Logged when the CO
2
sensor detects a kinked or blocked filter line.
 Logged when the CO
2
sensor detects the airway adapter is blocked.
 Logged when the CO
2
sensor detects that it is over temperature.
 Logged when the CO
2
sensor detects its result is out of range.
 Logged when a non-critical EtCO
2
error is detected.
 Logged when the Efficia DFM100 cannot communicate with the CO
2
sensor.
AwRR
/

Logged when AwRR alarms are turned on or off and any subsequent change.
 (low value) (high
value)
Logged when AwRR alarms are turned on and when there is a change in alarm
limits.
 (value, limit) Logged when the patient’s AwRR value is higher than the configured limit.
 (value, limit) Logged when the patient’s AwRR value is lower than the configured limit.
 (value) Logged when the Apnea alarm is displayed.
 (time) Logged when there is a change to the Apnea alarm Limit setting.
NBP
 Logged when a manual NBP measurement is requested.
 (frequency value) Logged when an automatic NBP measurement is requested (including frequency
value).
 Logged when an automatic NBP measurement is changed to manual (including
frequency value).
 (frequency) Logged when the NBP frequency is changed.
/ Logged when NBP alarms are turned on or off and any subsequent change.
Table 29 Event Information (Continued)
Logged Event Frequency