Philips Efficia DFM100 - Page 148

13: Data Management Event Summary
136
 (low value,
high value)
Logged when the Systolic NBP alarm limit is changed.
 (low value,
high value)
Logged when the Diastolic NBP alarm limit is changed.
 (low value,
high value)
Logged when the Mean NBP alarm limit is changed.
(value, limit) Logged when the patient’s Systolic NBP is higher than the configured limit.
 (value, limit) Logged when the patient’s Systolic NBP is lower than the configured limit.
(value, limit) Logged when the patient’s Diastolic NBP is higher than the configured limit.
 (value, limit) Logged when the patient’s Diastolic NBP is lower than the configured limit.
(value, limit) Logged when the patient’s Mean NBP is higher than the configured limit.
 (value, limit) Logged when the patient’s Mean NBP is lower than the configured limit.
 Logged when the NBP cuff fails to deflate after 3 minutes.
 Logged when the NBP cuff pressure reaches 300 mmHg/40 kPa.
 Logged when an NBP measurement fails to complete.
 Logged when the device detects a non-critical NBP failure.
 Logged when the NBP module detects a malfunction.
Defibrillation
 (value)  Logged when charging is initiated.
 Logged when the device is disarmed manually.
 (reason) Logged when the device disarms automatically. Reasons include:
: Logged when the automatic disarm is caused by a bad connection between
the device and the patient.
: Logged when the device is unable to reach the selected
energy during charging.
: Logged when the device reaches its configured auto-disarm period.
: Logged when, in AED Mode, the algorithm determines the
rhythm is not shockable.
: Logged when the device is turned off while charged.
: Logged in Synchronized Cardioversion Mode when a leads off condition is
detected in the synchronizing lead.
: Logged when, with the therapy cable connected, the
device detects a change in the paddles or pads type or if the therapy cable type
identification is not valid.
 (number) (energy) 
(impedance) (peak current)

Logged when a shock is delivered.
 (impedance) Logged when a shock is initiated but aborted before a full shock dose is delivered.
/ Logged when Sync is turned on or off and any subsequent change.
 Logged when a shock is initiated and completed but the full dose is not delivered.
Table 29 Event Information (Continued)
Logged Event Frequency