14: Configuration Overview
150
NOTE: The list of available alarm volumes is limited so that no choice less that the current setting for
Minimum Alarm Volume is presented. If the Minimum Alarm Volume is changed and the current
alarm volume is quieter than the new Minimum Alarm Volume, the current alarm volume is
changed to match the setting for the Minimum Alarm Volume.
Defines alarm volume level. , , , ,
Defines the minimum audible alarm level
available within use.
, , , ,
Defines voice prompt levels. , , , ,
Defines the volume level of audible beeps with
each QRS complex detected.
,, , ,
,
Defines if parameter values are displayed with or
without the corresponding measurement units.
,
Defines if when exporting clinical data a prompt
is displayed asking if you want to de-identify the
data.
,
Defines what type of patient information is
displayed.
, ,
Defines if all physiological alarms are latched
when first displayed.
,
Defines if the device automatically reminds you
every 3 minutes when alarms are suspended
indefinitely.
,
Table 32 General Settings (Continued)
Parameter Description Setting Choices User Setting
Table 33 Heart Rate/ECG Settings
Parameter Description Setting Choices User Setting
Selects the HR/ECG color. , , , , ,
,
Determines whether ECG size is automatically
adjusted to the maximum wave size without
clipping the wave sector. If auto-gain is off, the
gain is set to x1 (10mm/mV).
,
NOTE: Adjusting the ECG wave size on the display does not affect the ECG signal which is used for
arrhythmia analysis.
Selects the setting used to filter out AC line noise
from ECG data. Adjust setting to the power
frequency of your country.
,