Basic Orientation 2: Device Basics
17
Installing Paper
The Efficia DFM100 uses 50mm paper for printing.
To install printer paper:
1 Open the printer door by pulling up on the door latch. Allow the door to fall open (see
Figure 20).
2 If there is an empty or almost empty paper roll in the printer, pull up on the roll to remove it.
3 Examine the new roll of printer paper and remove any remaining adhesive residue from the
outer layer of paper.
4 Place the new roll of paper in the paper well, positioning the roll so that the end of the roll is on
the bottom as indicated by the symbol inside the printer.
5 Pull the end of the paper out past the roller.
6 Close the printer door.
7 Test the printer before putting the defibrillator back into service. See “Operational and Shift
Check” on page 157.
Figure 20 Installing Printer Paper
To Next Page
Loading...