2: Device Basics Basic Orientation
20
Cradle and Carry Bags
To install the Efficia DFM100 cradle and carry bags, all you need is a Phillips-head screwdriver.
To install the cradle and carry bags:
1 Open the cradle and set the Efficia DFM100 down snugly inside.
2 Taking one cradle edge at a time, lift the edge into place.
3 Using a Phillips-head screwdriver, screw two of the snaps provided into the predefined holes on
the cradle and into holes on the device. See Figure 23.
4 Use the other four snaps and repeat on the other side and back of the Efficia DFM100.
5 Stretch the long gray cradle strap across the top of the device and thread through the small metal
loop. Pull snug and secure in place with the hook and loop fasteners.
6 Take the carry bag with the plastic paper guide inside and align it with the printer on the side of
the device. Snap the bag into place, starting with the bottom first and then the top. Press the
hook and loop fasteners together. Tug lightly to confirm a solid connection.
7 Repeat Step 6 with the other side bag and the rear bag. See Figure 23.
8 Optional tray cover pouch: If you want to install the tray cover pouch, use the hook and loop
strip to fasten one edge of the bag through the metal loop on one side of the device. Stretch the
pouch across the paddle tray and fasten the other side. Tug lightly to confirm a solid connection.
9 Optional shoulder strap: Hook the strap into place, using the front metal loops on each side of
the cradle.
NOTES: When snapping the therapy/printer side bag in place, confirm that the printer paper path is clear so
the strip can come out of the printer freely.
For in-hospital use, the side carry bags can be installed without using the cradle.
Figure 23 Attaching the Cradle and Side Carry Bags
To Next Page
Loading...