Philips Efficia DFM100 - Displaying an Annotated ECG

4: ECG Monitoring Monitor View
56
Displaying an Annotated ECG
You may choose to display an annotated ECG with arrhythmia beat labels in Wave Sector 2. The
same ECG source appearing in Wave Sector 1 is displayed in Wave Sector 2 with a six-second delay.
 appears near the waveform. White arrhythmia beat labels also appear. See Table 6 for beat
label classifications.
 To display an annotated ECG:
1 Press the Smart Select knob.
2 Turn the Smart Select knob to highlight
 and press the Smart Select knob.
3 Select
 and press the Smart Select knob.
4 Select
 and press the Smart Select knob.
Table 6 Arrhythmia Beat Labels
Label Description Where Displayed
 Normal
Above QRS
 Ventricular Ectopic
 Paced
 Learning Patient’s ECG
 Insufficient information to classify beats
 Pacer Spike Above waveform, where pacer spike was
detected (If the patient is both atrially and
ventricularly paced, the display shows two
marks above the waveform aligned with the
atrial and ventricular pacing.)
 Biventricular Pace Pulse Above waveform where the biventricular pace
pulse was detected
 Artifact (noisy episode) Above waveform where noise was detected
 Inoperative condition (e.g. there is a lead
off)
Above waveform; at start of a technical alarm,
every second of the alarm and at the end
 Pause, Missed Beat, No QRS Above waveform where condition detected