Espresso Philips Service Center (EPSC)
EPSC is the Service tool to upload the software on the machine and run the diagnostic mode.
It can be downloaded from the following link: https://www.epsc.versuni.com/ServiceCenterPortal
The application can be used only in combination with the Saeco Programming Device:
Cod. 996530009845 “KIT PROGRAMMER SERKIT SSC2”.
A new cable 421946047151 “WIRING SERPROG OMN PROGRAMMER ASSY.” is required.
They can be ordered as spare parts.
All details related to the registration and operation are explained in the enclosed Quick start guide
(QSG).
Espresso Philips Service Center– Quick Start Guide
Press the icon to view the document
To open the attached document is necessary to save the service manual on your PC.
The main Diagnostic Parameters description is available on the GDA_114331.
In order to connect the machine to the PC, we need to remove the back panel, which will expose the complete
mainboard
REMEMBER: The board is working at 230V
Only for connected models: EP2520/10 and EP3546/70 in order to connect the machine to the PC, re-
move the wi- cable and connect the programmer cable. It’s only possible to run the diagnostic read. The
software update will be run via wi-.
Please take extra care before you start to open the machine or connect/disconnect the programmer ca-
ble, as till the USB programmer, high voltage is going through
Functions/features explanation
To Next Page
Loading...
