Solutions
Empty the dust compartment
(see chapter 'Cleaning',
section 'Emptying the dust
compartment')
Charge the appliance (see
chapter 'Preparing for use',
section 'Charging the
appliance').
Clean the filter unit (see
chapter 'Cleaning', section
'Emptying the dust
compartment').
Remove the obstruction from
the nozzle.
Reinsert the filter unit. See
chapter 'Cleaning' for
instructions about placing the
filter unit in the dust
compartment.
Place the filter unit in the dust
compartment. See chapter
'Cleaning' for instructions
about placing the filter unit in
the dust compartment.
Causes
If this problem is not caused
by any of the factors
mentioned above, please
contact the Philips Customer
Care Centre in your country.
The dust compartment is full.
The batteries are not fully
charged.
The filter unit is dirty.
The nozzle is clogged.
The filter unit has not been
placed properly in the dust
compartment.
The filter unit has not been
placed in the dust
compartment at all.
Problem
The appliance
does not
clean
floors/the
suction power
is low.
Dust escapes
from the
appliance.
ENGLISH12