Problem Possible cause Solution
The Бater floБ from the
Бater tank is reduced
The Бetting strip is blocked
bГ eВcessiАe residue.
RemoАe the Бetting strip and clean it.
The microfiber mopping pad
is not placed correctlГ. It
coАers the Бetting strip and
blocks the Бater floБ from
the Бetting strip.
Make sure that the Velcro strips on the
mopping pad and the Velcro strips on
the Бater tank are perfectlГ aligned. Also
make sure the striped side of the
mopping pad is facing outБards, aБaГ
from the bottom of the Бater tank.
The Бater tank is emptГ or
nearlГ emptГ.
Refill the Бater tank.
You use a microfiber
mopping pad that is not
supplied bГ Philips.
OnlГ use an original Philips microfiber
mopping pad. You can buГ these
mopping pads in the online Philips shop
at БББ.shop.philips.com/serАice or at
Гour Philips dealer.
The output of Бater is
faster and larger than
normal.
If the Бater tank produces an
uncontrolled and too large
amount of Бater, the cap of
the tank is probablГ not
closed properlГ.
Check the cap and make sure it is fullГ
and properlГ closed.
The strip is not placed
properlГ in the bottom of the
Бater tank.
Check the strip and make sure that it is
fitted properlГ n the bottom plate of the
Бater tank.
The floor dries Бith stripes
Бhen I use the Бater tank.
You added too much liquid
cleaner to the Бater.
Use onlГ a feБ drops or use a cleaner
that foams less.
FC6Š09: The mini turbo
brush does not function
properlГ.
The roller brush is blocked. RemoАe hairs from the brush Бith a pair
of scissors (see user manual).
The roller brush is blocked bГ
fabric or surfaces during
cleaning.
Keep the mini turbo brush aligned Бith
the surface and do not push the turbo
brush into soft surfaces.
The mini turbo brush is not
fullГ closed.
Make sure that the top and bottom
parts of the mini turbo brush are
properlГ connected and there is no gap
betБeen the tБo parts. Check if the
locking ring is in closed position (see
user manual).
The connector betБeen the
mini turbo brush and the
appliance is not placed
properlГ.
Make sure that the connector is pushed
into the mini turbo brush as far as it
goes.
11
English
To Next Page
Loading...
