Philips FW 339C - Operating the System; System Power and Source Selection; Demonstration Mode and Easy Set

(aie | ‘
OPERATING THE SYSTEM
MINI HIFI SYSTEM
TAPE 1¢ TAPE 2 VRE CO1-CO2. Cos BAND
Important:
Before you begin operating the system, complete
the preparation procedures.
Demonstration mode
The system has a demonstration mode that shows the
various features offered by the system. Whenever the
system is switched on from the wall socket, the
demonstration mode will start automatically.
Notes:
— During demonstration mode, if you press any source
(or standby-on) button, the system will switch to the
respective (or standby) made.
— When the system is switched to standby mode, 5
seconds later, the demonstration mode will resume.
SURROUND CONTROL
To cance! demonstration mode
e Press andhold STOP MM (on the system only) for 3
seconds to stop the demonstration.
~ The demonstration mode will be switched off
permanenily.
— The system will switch to standby mode.
Easy Set
EASY SET allows you to store all available radio stations
in a particular band (FM, MW or LW) automatically.
e Press and hold STANDBY®ON (on the system only)
for 2 seconds; when the system is in standby or
demonstration mode.
— "EASY SET" will be displayed and followed by
"TUNER.
— EASY SET will start with the last active band.
— All available radio stations with sufficient signal
strength will be stored or until 40 presets are filled.
Notes :
— When EASY SET is used, all previously stored stations
will be erased.
— the last preset station will appear on the display
when EASY SET is completed.
Switching the system ON
e Press STANDBY®ON (on the system only), CD,
TUNER, TAPE or AUX.
You can also switch on the system by pressing any one of
the 3 CD DIRECT PLAY buttons.
Switching the system to standby mode
e Press STANDBY®ON again.
— The system will switch to standby mode.
Selecting the Source
e Press the respective source selection button: CD,
TUNER, TAPE or AUX.
— The display indicates the selected source.
Note:
— Foran external source, make sure that you have
connected the audio left and right QUT terminals of
the external equipment (TV, VCR, Laser Dise or DVD
player) to the AUX IN terminals.