20
English
TIMER MAINTENANCE
5 Press CLOCK/TIMER to store the start
time.
™ The TIMER is now set.
™ The TIMER flag remains on the
display.
• To exit without storing the setting, press
Ç.
• At the preset time, the TIMER will be
activated.
™ The selected source will be played.
Notes:
– During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
– If the source selected is TUNER, the last
tuned frequency will be switched on.
– If the source selected is CD, playback
will begin with the first track of the last
selected disc. If the CD trays are empty,
the TUNER will be selected instead.
– If the source selected is TAPE 1, and if
the preset time is reached during high
speed dubbing, the TUNER source will
be selected instead.
Maintenance
Cleaning the Cabinet
• Use a soft cloth slightly moistened with
a mild detergent solution. Do not use a
solution containing alcohol, spirits,
ammonia or abrasives.
Cleaning Discs
• When a disc
becomes dirty, clean
it with a cleaning
cloth. Wipe the disc
from the center out.
• Do not use solvents
such as benzine,
thinner, commercially
available cleaners, or antistatic spray
intended for analog records.
Cleaning the CD lens
• After prolonged usage, dirt or dust may
accumulate at the CD lens. To ensure
good playback quality, clean the CD lens
with Philips CD Lens Cleaner or any
commercially available. Follow the
instructions supplied with the Lens
Cleaner.
Cleaning the Heads and the Tape Paths
• To ensure good recording and playback
quality, clean the heads, the capstan(s),
and pressure roller(s) after every 50
hours of tape operation.
• Use a cotton swab slightly moistened
with cleaning fluid or alcohol.
• You can also clean the heads by playing
a cleaning tape through once.
Demagnetizing the heads
• Use a demagnetizing tape available at
your dealer.
To cancel the TIMER
1 Press CLOCK/TIMER for more than 2
seconds.
2 Press Å to cancel the timer.
™ “CANCEL” will be displayed.
™ The TIMER flag disappears from the
display.
To start the TIMER again
(for the same
time)
1 Press CLOCK/TIMER for more than 2
seconds.
2 Press CLOCK/TIMER again to store the
start time and the selected source.
To Next Page
Loading...
