Philips GC9920 - Stand Disassembly Advice - Part 1; Wheel, Cover, and Cord Winder Removal; Stand Electronics and Wiring Removal

GC9920
9-19
DISASSEMBLY ADVICE - STAND
WHEEL ASSY 31
CAP WHEEL PAINTED 32
E-RING 33
Disassemble CAP WHEEL PAINTED 32
Disassemble E-RING 33
Disassemble WHEEL ASSY 31
BACK COVER TOP 21
BACK COVER BOTTOM 22
AUTO CORD WINDER 38
Remove screws M1 - M4
Disassemble BACK COVER TOP 21
Remove screws N1 - N6
Disassemble BACK COVER BOTTOM 22
Remove screws P1, P2, P3
Disconnect quick-connectors E, L, N at the back of
AUTO CORD WINDER 38
Disassemble AUTO CORD WINDER 38
SPRING LIFT COLUMN ASSY 27
Remove IRONING BOARD-MOVING COLUMN
assy (refer DISASSEMBLY ADVICE-
MOVING COLUMN)
Remove screws Q1, Q2
Disassemble SPRING LIFT COLUMN ASSY 27
FOOT ASSY 28
Remove screws R1 - R4
Disassemble FOOT ASSY
PANEL LEFT ASSY 24
SMPS 36
STAND ELECTRONICS 37
WIRE ASSY LED - STANDBY 39
WIRE ASSY LED - WATER TANK 41
Remove screw S1
Remove screws T1, T2, T9, T10
Disassemble PANEL LEFT ASSY 24
Disconnect quick-connector W7 on STAND
ELECTRONICS 37
Remove LED cover
Disassemble WIRE ASSY LED - STANDBY 39
Disconnect quick-connector W8 on STAND
ELECTRONICS 37
Disassemble WIRE ASSY LED - WATER TANK 41
Remove screw U
Disconnect quick-connectors L4, N4 & 4-pole cable W3
on STAND ELECTRONICS 37
Disassemble SMPS 36
Remove screw V
Disconnect all connectors on STAND
ELECTRONICS 37
Disassemble STAND ELECTRONICS 37