• Set the section switches
- If you wish to treat the entire body, set both section
switches Q to position I (fig. 9).
- If you wish to treat a section of the body (upper part or legs),
set only the corresponding section switch to position I.
- Ensure that the other switch is in position O (fig. 10,11).
- Pull the distance meter H
out of the appliance until
the required height
(e.g. 90 cm or 36.5").
- Loosen locking screw G
(one or two turns anti-
clockwise).
- Slide out and adjust the
stand till the required
height.
- Screw in locking screw G
firmly (turn clockwise).
- Moving the lever in the
direction of the arrow will
make the meter roll up
inside the appliance.
The solarium is now ready
for use.
7
To Next Page
Loading...
