3 Remove the comb and clean it with the brush
or rinse it under the tap.
Caution: Make sure that the comb is dry before
you reattach it to the appliance.
4 Press the release button (1). The cutting unit
comes off the appliance (2).
5 Clean the cutting unit with the brush or rinse
it under the tap. Shake off excess water and
leave to dry.
Do not dry the cutting unit with a towel, as this
may damage the cutting element.
Caution: Make sure that the cutting unit is dry
before you reattach it to the appliance.
6 Clean the inside of the appliance with the
cleaning brush.
Never immerse the appliance in water or rinse it
under the tap.
7 Insert the lug of the cutting unit into the
guiding slot (1) and push the cutting unit back
onto the appliance (2).
1
2
1
2
ENGLISH
27
HC7462-15_EN_A6_CS6.indd 27 16/10/25 17:17
To Next Page
Loading...
