1 Place a bowl under the milk frothing pipe.
2 Press the CLEAN button on the milk jug lid for a few seconds.
Hot water comes out of the milk frothing pipe as long as you press
the CLEAN button.
1 Remove the lid from the milk jug and detach the milk frothing pipe
and the milk intake tube.
2 Clean all parts thoroughly with hot water and some washing-up
liquid or in a dishwasher.
Make sure there are no milk residues inside the two holes in the lid of the
milk jug.
3 Reattach the milk intake tube and the milk frothing pipe, put the lid
on the milk jug and put the milk jug back into the appliance.
The appliance is preset to dose specic amounts of coffee and milk for
cappuccino and latte macchiato. You can change these quantities as follows:
1 Fill the milk jug with milk.
2 Put a cup under the coffee spout and the milk frothing pipe.
3 Press the cappuccino button or the latte macchiato button for at
least 5 seconds.
4 Release the button when ‘PROGRAM TO SET VOL. - MILK
FOR CAPPUCCINO’ or ‘PROGRAM TO SET VOL. - MILK FOR
MACCHIATO’ appears on the display.
After a few seconds, milk starts to come out the milk frothing pipe.
5 When the milk in the cup reaches the required level, press the same
button again to set the new quantity.
After a few seconds, the appliance starts to brew coffee and
‘PROGRAM TO SET VOL. - COFF. FOR CAPPUCCINO.’ or
‘PROGRAM TO SET VOL. - COFFEE FOR MACCHIATO’ appears on
the display.
6 When the coffee in the cup reaches the required level, press the
same button again to set the new quantity.
’SETTING DONE’ appears on the display. The appliance now
produces the set quantities until you change them again.
,
,
,
,
EnglisH 15
To Next Page
Loading...
