Philips HD7466 - Page 8

The light goes on.
Let the appliance run until the water tank is completely empty.
4 Switchtheapplianceoffwhenallthewaterisinthejug.
5 Lettheappliancecooldownforatleast3minutesbeforeyoustart
brewingcoffee.
Using the appliance
1 Openthelid(Fig.3).
2 Fillthewatertankwithfresh,coldwater(Fig.4).
The water level indicator shows the amount of water in the water tank.
The graduations correspond to large cups (125 ml). Make sure that the
water level does not exceed the MAX indication.
3 Closethelid.
4 Placethejugonthehotplate.
5 Openthelterholder(Fig.6).
6 Takeapaperlter(type1x2orno.2)andfoldthesealededgesto
preventtearingandfolding.
In some countries this coffeemaker comes with a permanent lter. In that
case you should not use paper lters.
7 Putthelterinthelterholder.
8 Putpre-groundcoffee(lter-negrind)inthelter(Fig.7).
For large cups: use one heaped measuring spoon of ground coffee for
each cup.
For small cups: use one level measuring spoon of ground coffee for each
cup.
9 Closethelterholder.
10 Switchtheapplianceonbypressingtheon/offswitch(Fig.5).
Note: The light goes on.
ENGLISH8