4 ECG and Arrhythmia Monitoring Preparing to Monitor ECG
50
4
If not preconnected, connect the ECG patient cable.
– Align the keyed patient cable connector with the ECG port on the Measurement module, as
shown in Figure 31.
– Push the patient cable firmly into the ECG port until the white portion is no longer visible.
Figure 31 ECG Cable Connection
If monitoring via multifunction electrode pads:
1 If not preconnected, connect the pads cable to the HeartStart MRx. See Figure 40 on page 65.
2 Connect the pads to the pads cable. See Figure 41 on page 66.
3 Apply the pads as directed on the package.
NOTE If monitoring for extended periods of time, monitoring electrodes and multifunction electrode pads
may need to be changed periodically. Refer to the manufacturer’s documentation for how often to
replace the monitoring electrodes or pads.
2
1
ECG
ECG
CO
2
To Next Page
Loading...
