Philips HF3330 - Page 17

, The display shows an alarm time of 12:00 a.m. and shows the
normal clock time, but the alarm mode is off.
Note: The appliance remains switched on in demo mode until it is switched
off.
To deactivate the demo mode, press and hold the on/off button for 10
seconds.
Using the appliance
1 Press the on/off button briey to switch on the appliance (Fig. 8).
, The touchscreen display goes on.
Note: If you do not touch the display or press any button for 5 minutes when
the display is switched on and the appliance operates on battery power, the
appliance switches off automatically to save battery power.
Note: If you want to switch off the appliance, press and hold the on/off
button for 2 seconds.
2 Briey press the on/off button again to switch on the LED panel.
, The timer counts down the set time.
Note: The default treatment time is 15 minutes. Use the timer to change the
treatment time (see section ‘Setting the timer’ in chapter ‘Preparing for use’).
, When the countdown is nished, the LED panel switches off
automatically.
Note: If you want to switch off the LED panel before the countdown is
nished, press the on/off button briey.
3 Press the plus or the minus button to change the light
intensity (Fig. 11).
You can increase or decrease the intensity in increments of 25%.
Pausing a session
1 Press the on/off button or press the minus button to reduce the
intensity to 0%.
, The remaining minutes of the session are still shown on the display.
ENGLISH 17