Philips HF3500 Series Manual

2 To select the desired radio frequency, press the « and » buttons.
Tip: To scan radio frequencies automatically, press and hold the « or » button
for approx. 2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and
move it around until you have found a position at which reception is best.
Note: The current radio frequency is shown in the display for 5 seconds, before
clock time is shown again.
3 To switch off the radio, press the radio on/off button again.
Volume
1 To set the volume, press the volume increase or decrease button.
You can choose a volume level between 1 and 10.
Note: The volume level you have selected is automatically set as the volume
level for the alarm as well.
Setting the display brightness
1 Press the Display brightness button to adjust the display brightness.
The brightness of the display will change from high-medium-low-very low.
Demo mode
If you want a quick demonstration (90 seconds) of the gradually increasing
light intensity and sound level, switch on the test function of the appliance.
1 Press and hold the alarm button for at least 3 seconds.
2 The appliance starts the demonstration of the alarm.
3 To switch off the demonstration, press and hold the previously
pressed alarm button for 3 seconds again.
ENGLISH 9

Philips HF3500 Series Specifications

General

Type	Wake-up Light
Power	7.5 W
Non-slip Rubber Feet	Yes
Tap Snooze	Yes
Display	LED
Light Intensity	200 Lux
Sunrise Simulation	Yes
Alarm Type	Beep
Color of Light	Yellow
Snooze Function	Yes
Display Dimmer	Yes