Philips HF3519 - Electromagnetic fields (EMF); Cleaning and storage; Recycling; Warranty and support

10
English
Problem Solution
Perhaps you switched off the alarm function.The alarm icon is visible on the
display when the alarm function is active.
Perhaps you set a volume level and/or light intensity level that is too low. Set
a higher volume level and/or light intensity level in your wake-up profile (see
user manual for more information).
The alarm went off
yesterday, but it did not go
off today.
Perhaps there was a power failure that lasted longer than the time back-up.
The set clock time is lost. You have to set the correct clock time again.
I wanted to snooze, but
the alarm did not go off
again after 9 minutes.
Tap on the top of the Wake-Up Light to snooze. If you press the alarm
button, the FM button or the MENU button, the alarm function will be
deactivated.
The light wakes me too
early.
Perhaps the light intensity level you have set is not appropriate for you. Try a
lower light intensity level if you wake up too early. If light intensity 1 is not
low enough, move the appliance further away from the bed.
The light wakes me too
late.
Perhaps the appliance is positioned at a lower level than your head. Make
sure the appliance is located at a height at which the light is not blocked by
your bed, duvet or pillow. Also make sure the appliance is not placed too far
away.
HF3532, HF3531, HF3521: I
am unable to switch the
midnight light function
on/off.
If you are unable to switch the midnight light on or off, try tapping faster or
slower on top of the device.
Specifications
Adapter
Manufacturer PHILIPS
Type number HF12; HF20
Rated input voltage 100 – 240VAC
Rated input frequency 50 / 60Hz
Rated output voltage 24.0VDC
Rated output current 0.5A (HF12); 0.75A (HF20)
Rated output power 12.0W (HF12); 18.0W (HF20)
No-load power <0.1W
Efficiency class VI
Safety classification Class II power supply