12
English
- -
You can select the model of your robot by scanning the QR code on top of
the robot, or you can look up the model number yourself on the type plate at
the back of the station.
3 Install the station within the correct dimensions for placement.
4 Press and hold the on/off button and home button at the same time for three
seconds. The lights in the buttons will flash orange to indicate that the robot
is in in Wi-Fi set-up mode.
5 Pair the robot with the Wi-Fi in the app.
6 Click the join button if it's visible in the app to connect with the 'Philips
robot' network.
Philips robot_XXXX
Settings
WLAN
Note: If the join button is not visible in the app, leave the app and go to
Wi-Fi under 'Settings' on your mobile device. There you can select the 'Philips
robot' network and connect to it.
If the Wi-Fi pairing fails:
-
Check if you have selected the correct robot model.
-
Check your Wi-Fi connection
-
Check if you entered the correct Wi-Fi password
-
Check if the robot is still in Wi-Fi set-up mode.
Note: You can recognize this if the lights in the two buttons on the robot
are still flashing orange.
Note: If you are unable to solve the problem, visit
www.philips.com/myrobot7000 for support information and the contact
details of Consumer Care.
To Next Page
Loading...
