Philips HP3132 - Page 9

Replacing the sun lamps and/or UV-A filter
Wiring instructions - for U.K. oni
In
the
course
of
time
(in
normal
family
use
after
some
7
y
years)
the
efficiency
of
the
sun
lamps
will
gradually
WARNING
-
THIS
APPLIANCE
MUST
BE
EARTHED
decrease.
t : F F j *IMPORTANT”
if this happens, you may increase the tanning session The wires in the mains lead are coloured in
time or have the sun lamps replaced. accordance with the following code:-
The UV-A filter glass protects you against harmful ore EO EON < REET BAL:
(high-frequency) UV. For that reason have a defective or BROWN - LIVE
damaged filter glass replaced right away.
: As the colours of the wires in the mains lead of this
pave
We
aie
a
and
the
wham
al
ace
ceneeee
appliance
may
not
correspond
with
the
markings
y by authorized service personel: only e : ify ; :
the required skill and tools to do the job and will aes the torenitvals lr your, plug Ploceed as
dispose of the original replacement parts. The wire which is coloured GREEN-AND-YELLOW
(For
service
numbers
please
refer
to
section
"General
estes
eed
i
ae
Sabet
ce
aie
description”) GREEN, or GREEN-AND-YELLOW.
The tamps of solariums contain substances which may ee ee ee feta a ieEN
_ pollute the environment. When discarding old lamps, coloured BLACK
please ensure that they are separated from the normal The wire which is coloured BROWN must be
household refuse and that they are disposed of at an connected to the terminal which is marked with a
officially assigned place. letter L or coloured RED.
This product is manufactured to comply with the radio
interference requirements of the council directive
87/308/EEC/87/310/EEC.
Solarium does not function as required?
If the solarium should not function as required, this
may be due to a defect. In this case do not hesitate
to apply to your dealer or to a Philips Service Centre.
However, it is also possible that the appliance has not
been installed according to the instructions or is used
improperly. If this is.the case, you will be able to
solve the problem rightaway.
You may check the following section before
contacting your dealer or Philips Service Centre.
Problem Possible cause
e
Solarium
does
not
switch
on.
-
Mains
plug
is
not
in
wall
socket.
- No mains power. (Please check with other appliance.
- The lamps are still too warm to restart. (Allow the lamps to cool
down
for
approx.
3
minutes.)
.
- Ventilation was insufficient and the automatic thermal safety device
has switched the appliance off.
Remove the cause of overheating (e.g. take towel away from
ventilation opening) and wait for 10 minutes before switching on again.
® The power fuse switches the mains - Check the fuse to which the solarium has been connected.
power off when switching on or while The proper type for your solarium is a 13 A or 16 A normai fuse or a
using
the
solarium.
slow
reacting
automatic
fuse.
3
:
@
The
browning
is
not
according
to
-
You
followed
a
course
which
is
not
the
most
appropriate
for
your
your
expectations.
skin
type.
- The operational distance is larger than indicated.
~ After using for a long time the UV production of the lamps
decreases. (With normal use this will not be noticeable before years.)
You may compensate for this effect by selecting longer treatment
times or have the sun lamps replaced.
- You use an extension cord which is too long and/or does not allow
the required power levels. Please apply to your dealer.
10