C
3 Remove the metal clip by means of a
screwdriver.
C
4 Open the housing.
C
5 Pull the battery holder out of the
appliance.
C
6 Insert a screwdriver into the small slot in
the printed circuit board marked with an
arrow.Push the screwdriver down until
part of the printed circuit board breaks
off.
C
7 Separate the battery from the plastic part
by means of a screwdriver.
8 Dispose of the battery and the other
components in an environmentally safe
way.
Do not connect the appliance to the mains again
after it has been opened!
ENGLISH12
To Next Page
Loading...
