Mini chopper quantities and processing times (HR1615 only)
Ingredients Chopping
quantity
Time Speed
Onions & eggs 100g 5 x 1sec. 1-4
Meat 120g (max) 5sec. turbo
Herbs 20g 5 x 1sec. 8-12
Parmesan cheese 50-100g (max) 15sec. turbo
Nuts and almonds 100g 20sec. turbo
Garlic 50g 5 x 1sec. turbo
Extra-large chopper quantities and processing times
(HR1617 only)
Ingredients Chopping
quantity
Time Speed
Onions and eggs 200g 5 x 1sec. 1-4
Meat 200g 10sec. turbo
Herbs 30g 10 x 1sec. 8-12
Nuts and almonds 200g 30sec. turbo
Dry bread 80g 30sec. turbo
Parmesan cheese 200g 20sec. turbo
Dark chocolate 100g 20sec. turbo
3 Put the lid on the chopper bowl (Fig. 6).
4 Fasten the motor unit onto the chopper lid (‘click’) (Fig. 7).
5 Put the plug in the wall socket.
6 Press the on/off button or the turbo speed button to switch on the
appliance.
Note: If the ingredients stick to the wall of the chopper bowl, loosen them with
a spatula or by adding liquid.
Note: Do not process more than 1 batch without interruption. Let the appliance
cool down for 5 minutes before you continue processing.
Whisk (HR1617 only)
The whisk is intended for whipping cream, whisking egg whites, desserts etc.
1 Connect the whisk to the coupling unit (‘click’) (Fig. 8).
2 Connect the coupling unit to the motor unit (‘click’) (Fig. 9).
3 Put the ingredients in a bowl.
See the table for the recommended quantities and processing times.
Whisking quantities and processing times (HR1617 only)
Ingredients Whisking quantity Time
Cream 250ml 70-90sec.
Egg whites 4 eggs 120sec.
Tip: When you beat egg whites, use a large bowl for the best result.
Tip: When you whip cream, use the beaker to avoid splashing.
Tip: To prevent splashing, start at a low speed setting and continue with a higher
speed after approx. 1 minute.
Note: Do not process more than 1 batch without interruption. Let the appliance
cool down for 5 minutes before you continue processing.
4 Put the plug in the wall socket and press the on/off button.
5 After approx. 1 minute, you can press the turbo button to continue at
turbo speed.
Cleaning (Fig. 10)
Do not immerse the motor unit, the whisk coupling unit (HR1617
only), the mini chopper lid (HR1615 only) and the extra-large chopper lid
(HR1617 only) in water.
1 Unplug the appliance.
2 Press the release buttons on the motor unit to remove the accessory
you have used.
3 Disassemble the accessory.
Tip: You can also remove the rubber rings from the chopper bowls for extra
thorough cleaning.
4 See the separate cleaning table at the end of this user manual for
further instructions.
Tip: For quick cleaning, pour warm water with some washing-up liquid in the
beaker, insert the blender bar and let the appliance operate for approx. 10
seconds.
Storage
1 You can store the motor unit, the blender bar and the whisk (HR1617
only) in the beaker (Fig. 11).
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this you help to preserve the environment (Fig. 12).
Accessories
You can order a direct-driven mini chopper (under service code number
4203 035 83450) from your Philips dealer or a Philips service centre as an
extra accessory for the HR1617, HR1615 and the HR1614.
Use the quantities and processing times of the mini chopper for this
accessory.
Guarantee and service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you nd its phone number in the worldwide
guarantee leaet). If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
To Next Page
Loading...
