General description (fig. 1)
A On / off switch guard
B Cord storage
C Remainders holder (4822 466 83219)*
D Carriage (hinged) (4822 441 31396)*
E Blade lock
F Circular blade (stainless steel)
(4822 690 40311)*
G Support table (4822 441 31395)*
H Stop plate (4822 441 31394)*
I Cutting width scale (max. 20 mm)
J On / Off button
K Cutting width control
* Spare parts are available for replacement. Apply to
your dealer referring to the service number (...)*.
Making ready for use
- Unwind the mains cord to the desired length and
secure it (fig. 2).
- Fold down the support table (fig. 3).
- Put the rear section of the carriage into a vertical
position.
See the arrows in figs. 4-5.
- Attach the carriage to the support table (fig. 6-7).
- Attach the remainders holder to the carriage
(fig. 8).
Switching on and off
The switch guard (A) locks the On / Off button (J), to
prevent unintended switching on.
- Press and hold the switch guard. Push down the
On/Off button (fig. 9).
- Release the switch guard (fig. 10).
As long as the On / Off button remains in down
position, the appliance is switched on.
- To switch off, just release the On / Off button
(fig. 11).
The switch guard springs back into its original
position.
Cutting width setting
- Set the desired cutting width (max. 20mm) by
rotating the control knob. Refer to the scale
(fig. 12-13).
• For safety, always rotate the control knob
anti-clockwise until it stops. (Minimum
cutting width.)
Hinged carriage and remainders lock
• For safety: Always place the remainders
holder on the carriage for cutting rest
pieces.
- For compact storage, see fig. 4-5. (Proceed in
reverse.)
Use
The universal cutter slices bread, meat, sausage,
cheese, vegetables and fruit easily (fig. 14-15).
Press the food to be sliced lightly against the stop
plate and slide slowly against the running blade.
Please note: The appliance is intended for domestic
use.
Do not operate the appliance longer than 10 minutes
without a pause.
4
English
Important
• Read the instructions in conjunction with
the illustrations before using the
appliance.
• Care must be taken when handling the
circular blade as it is very sharp.
• Do not allow children to operate the
appliance.
• Remove the mains plug from the wall
socket after use.
• If the mains cord of this appliance is
damaged, it must only be replaced by
Philips or their service representative, as
special tools and/or parts are required.
• Prior to initial use, clean all the parts
which come into contact with food.
• Never immerse the motor unit in water
or any other liquid. Do not rinse either.
• Keep these instructions for future
reference.
To Next Page
Loading...
