2 - 12 - 1
System , Region Code , etc. Setting Produre
1)System Reset
a) press “system “ buttom on R/C,TV show “setup“
b) select the menu using the and
on R/C
c) go preference page to do sysytem reset
3)Version Control Change
a) In open model, press “1“ “5“ “9“ on R/C
b) press “ok” buttom to com rm
c) TV will show message as below:
2)Region Code Change
a) press the “stop” buttom on R/C in open model
c) press”7” “3“ “4“ “4“ “6“ “6“ on R/C,then input desired number
to change region code :
1 USA
2 EU
3 AP
4 Australia ,NZ , Latam
5 Russia , INDIA
6 CHINA
Current model 3000-55 3000-98
Ver 00.18.00-70301-00 region : 4 / 3
Servo: OF.60.00.00
8032: 05.00.04.06 RISC:00.00.02.07
IF current model does not match you set use down arrow
key on the remote to change
4)Password Change
a) press “system “ buttom on R/C,TV show “setup“
b) select the menu using the and
on R/C
c) go preference page select “password“ to change
* 000000 is default password supplied.
5)Check on the Sofeware Version
a)open the CD Door
b) press “display“ buttom on R/C
c) TV will show the version on screen
6)Upgrading new sofeware
a)open the CD Door,then insert the CD-R program disc
b)close the DOOR
c) TV will show:
“loading“
pop message“upgrading“
“writing” about 2 minutes
“done “
* the latest upgraded is in version VER 00.18.00-70301-00
C A UT ION !
This information is con nc ial and may not
be
distributed. Only a quad service
person should reprogram the R egion
Code.
To Next Page
Loading...
