2 - 12 - 1
System , Region Code , etc. Setting Produre
1)System Reset
a) Press “OPTIONS“ button on R/C,TV will show setup menu
b) Select the menu using the and
on R/C
c) Go preference page to do system reset
2)Region Code Change
a) In open model, press”9” “9“ “9“ “9“ on R/C,then input desired
number to change region code :
1 USA
2 EU
3 AP
4 Australia ,NZ , Latam
5 Russia , INDIA
6 CHINA
3)Version Control Change
a) In open model, press “1“ “5“ “9“ on R/C
b) Press “ok” button to con rm
c) TV will show message as below:
6)Produce to Change Tuner Grid
(only applicable for certain regions)
In some countries ,the frequency step between adjacent channels
in the (AM/MW)/FM band is 9kHz/50kHz (10kHz/100kHz in some
areas).
a) Press “source” to select “FM” or “AM”
b) In “FM” or “AM” playback mode, press & hold “play/pause” button
until “Grid 9” or “Grid10” appears
note :repeating the same action will toggle back to it previous tuning
grid setting.
* “grid 10” is default for /55/98/94 version, “grid 9” is default for /51
version and it doesn’s to change Tuner grid.
7) Upgrading new sofeware
a) Copy “sofeware les” into a CD-R
b) Open the CD Door,then insert the CD-R program disc
c) Close the CD Door
d) VFD will show:
“Loading“
“Erase” -- erase the ash memory
“Writing” about 1 minute
“done “
* the system will switch off and on again automatically.
e) OSD will show:
Current model HTS3156/93
Version: 00.15.04 Region :6
Servo:OF.60.00.00
8032:05.00.04.06 RISC: 00.00.02.02
IF current model does not match you set use down arrow
key on the remote to change
OK
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
4)Password Change
a) Press “OPTIONS “ button on R/C,TV will show setup menu
b) Select the menu using the and on R/C
c) Go preference page select “password“ to change
* 000000 is default password supplied.
5)Check on the Sofeware Version
a) Open the CD Door
b) Press “INFO“ button on R/C
c) TV will show the version on screen
upgrade le detected
Do you wish to continue with
the sofeware upgrade?
OK Cancel
f) Select “OK”, OSD will show:
upgrade in process...
V315X
please do not unplug or
switch off the device.
6)Trade model
a) Press “Open/Close “ button on R/C
b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or “TRA
OFF“
To Next Page
Loading...
