12
Play audio from TV or other
devices
Press AUDIO SOURCE repeatedly to select the
audio output of the connected device .
Play from an MP3 player
Connect and play audio les from an MP3 player
or other external audio devices.
1 Connect the MP3 player to the home theater.
2 Press AUDIO SOURCE repeatedly until
‘ MP3 LINK ’ appears on the display panel.
3 Press the buttons on the MP3 player to
select and play audio les.
Play from an iPod or iPhone
By connecting and installing a Philips Dock for iPod/
iPhone, you can use the home theater to play music,
movies and photos from your iPod or iPhone.
Note
Philips Dock for iPod/iPhone is sold separately. •
You can charge your iPod/iPhone on the dock •
while the home theater is in iPod mode.
Dock your iPod or iPhone
1 Connect the dock to the home theater and
connect the yellow composite cable from
the dock to the TV. For more information,
see the Quick Start provided with the dock.
2 Switch on the iPod or iPhone and place it in
the dock.
Listen to music
1 Dock your iPod or iPhone (see ‘Dock your
iPod or iPhone’ on page 12 ) .
2 Press DOCK for iPod on the home theater
remote control.
3 Browse on the iPod or iPhone screen to
select track.
4 Press OK to play the track.
Repeat play a speci c section
Select sections of audio or video for repeat playback.
1 During playback, press INFO .
2 Select [Repeat] > [Repeat AB] in the menu.
3 Press OK to mark the start point.
4 Press OK again to mark the end point.
Repeat play starts. »
To cancel repeat A-B, press
• INFO ,
select [Repeat] > [Off] , then press OK .
Note
Repeat play is only possible within a track/chapter. •
Play from radio
The home theater can store up to 40 radio stations.
1 Check that the FM antenna is connected.
2 Press RADIO .
“ » AUTO INSTALL...PRESS PLAY ’ appears
on the display panel if you have not
installed any radio stations. Press
.
3 Press the following buttons to control play:
Button Action
/
Selects a preset radio station.
/
Searches for a radio station.
Fine tunes a radio frequency.
Press and hold to erase the
preset radio station.
Press to stop the installation of
radio stations.
PROGRAM Manual: Press once to access
program mode, and press again
to store the radio station.
Automatic: Press and hold for ve
seconds to reinstall radio stations.
Note
AM and digital radio are not supported. •
If no stereo signal is detected, or if fewer than •
ve stations are found, you are prompted to
install the radio stations again.
For the best reception, place the antenna away
•
from the TV or other sources of radiation.
EN
To Next Page
Loading...
