Philips HTS3357/12 - Service Positions; Service Position A Details; Service Position B Details

3 - 2 3 - 2
Dismantling of the DVD Module
1) Loosen 4 screws “F” to remove the DVD Module as shown
in  gure 8.
Dismantling of the Power Board
1) Loosen 5 screws “D” at the top of the Power Board as
shown in  gure 7
Dismantling of the Control Board
1) Loosen 10 screws “E” on the top of control board as shown in
 g ure 6
SERVICE POSITIONS
Service position A
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
Service position B
D
Figure 7
E
Figure 6
F
Figure 8