Philips HTS3541 - Page 28

28EN
Step 2: Update the software
Caution
• Before you connect the USB ash drive to your home
theater, make sure that there is no disc in the disc
compartment, and the disc compartment is closed.
1 Connect the USB ash drive to your home
theater.
2 Switch your TV to the correct source for
your home theater.
3 Press (Home), and then select [Setup].
4 Select [Advanced] > [Software Update]
> [USB].
5 Follow the instructions on the TV to
conrm the update.
» When the software update is
complete, the home theater
automatically switches off and restarts.
If it does not, disconnect the power
cord for a few seconds, and then
reconnect it.
Note
• When the software update is in progress, do not turn
off the power or remove the USB ash drive.