Firmware Upgrade
Introduction
The upgrade version of this software is Version 26 and can be used to upgrade Philips HTS9800W/12,
HTS9800W/37 and HTS9800W/55 to the latest status.
The upgrade allows the HTS9800W improves CDDA recognition, SCART detection and Bass/Treble.
Upgrade Procedure
Ste
1
Check your current firmware version
1 Power up the set in DISC mode and make sure there is no disc inside the set, then press <DISPLAY>
button on the remote control.
2 The software version and other information are display on the TV screen as follows:
G69M1 VXX 9800-XX X XX
Servo : XXXXXXXX Reg:X
HDCP XXXX (PASS or FAIL)
Example :
G69M1 V26 9800-12 2 08 -> Indicates Software version 26, stroke version 12, OTP version 8.
Servo : 94110000 Reg:2 -> Indicates Servo version 94110000 and Region code 2.
HDCP PASS -> Indicates HDCP pass.
Note:
Do NOT upgrade your set if the software version number is higher than V26!
The firmware information is also useful when you call Philips Customer Care Center.
Ste
2
Download Firmware upgrade
1 Check you have the following tools:
• PC (Pentium III 300MHz processor or higher)
• CD-R/RW writer and writing application software
• Blank CD-R or CD-RW disc
• Internet access (broadband or high speed)
2 Click the link to download Firmware Upgrade to your PC
3 Unzip the .zip file
i) Do not rename the filename.
ii) Visit
http://www.winzip.com/ for downloads if you cannot open the .zip file.
1
To Next Page
Need help?
Picture/Display
Power
Loudspeakers
