Cord wrap on deluxe charger (select models)
If your model includes the deluxe charger cover and base, the travel charger is pre-installed inside
the cover. If you want to shorten the power cord, you can store excess cord in the cord wrap
feature built into the charger base.
1 To separate the charger cover from the charger base, press the two gray snap bars on the
charger base and pull the white charger cover upwards.
2 Wrap excess power cord around the gray charger base as shown in the picture. Be sure to
wrap the cord on the inside of the two snap levers.
3 When you have stored the excess cord, guide the power cord through the small groove in
the rear of the gray charger base.
4 Reattach the charger cover by pressing it down over the charger base until it snaps into
place.
Tip: For extra convenience during travel, you can remove the travel charger and use it without the
charger cover and charger base.
Cord warp on sanitizer with integrated charger
1 If your model includes the sanitizer, you can store excess cord using the cord wrap feature
built into the bottom of the sanitizer.
ENGLISH8
To Next Page