Note: Using the Easy-start feature beyond the initial ramp-up period
is not recommended and reduces Philips Sonicare effectiveness in
removing plaque.
Note: Each of the first 14 brushings must be at least 1 minute in length
to properly move through the Easy-start ramp-up cycle.
Traveling with the appliance
1 Open the travel case and remove the middle insert.
2 Place the charger base and wall adapter in the bottom of the case.
3 Insert the toothbrush handle underneath the elastic band in the
middle insert to ensure the handle stays in place while traveling.
4 Place the middle insert back into the travel case.
5 Brush heads can be stored in the netted pouch of the travel case.
Cleaning
Note: Do not clean the brush head, handle, charging base or USB
travel case in the dishwasher. The glass is dishwasher safe.
Toothbrush handle
1 Remove the brush head and rinse the metal shaft area with warm
water. Make sure you remove any residual toothpaste (Fig. 16).
Note: Do not push on the rubber seal on the metal shaft with sharp
objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
Note: Do not use isopropyl rubbing alcohol, vinegar or bleach to
clean handle as this may cause discoloration.
Brush head
1 Rinse the brush head and bristles after each use (Fig. 17).
2 Remove the brush head from the handle and rinse the brush head
connection with warm water at least once a week.
Charging Pad & Travel Pouch
1 Unplug the charger.
2 Use a damp cloth to wipe the surface of the charging pad and
travel pouch.
15
English
To Next Page
Loading...
