1. Turn off the system
2. Insert the connector on the foot switch cable into the receptacle on the front
of the system.
3. Secure the connector to the system by hand-tightening the retaining screws
on the connector.
Foot Switch Receptacle
External VCRs
You can connect the Mitsubishi HS-MD3000UA (NTSC) or HS-MD3000EA
(PAL) VCR to your ultrasound system as an external device. If your system has
an internal VCR installed, an external VCR provides only recording from the
system, and cannot support playback or be controlled from the system.
The system supports VCR control through the system control module only if
this VCR is installed on the system using the Philips installation kit for that model.
(For availability of this kit, contact your Philips representative.) If you connect
this VCR without the installation kit or connect any other VCR, you must control
it from the front panel controls on the VCR.
iE33 User Manual
110
4535 616 23901
Preparing the System
4
To Next Page
Loading...