Connecting an External VCR
1. Turn off the system and unplug the power cord from the power source.
2. Connect the audio cables between the Audio In on the VCR and the VCR
Audio output on the ultrasound system.
3. Connect the audio cable between the Audio Out on the VCR and the VCR
Audio input on the ultrasound system.
4. Connect an S-Video cable between the S-Video input on the VCR and the
S–Video output on the ultrasound system. (This connector is available
only if an internal VCR is not installed.)
5. Connect an S-Video cable between the S-Video Out on the VCR and the
right S–Video input on the system; the left S-Video input is not
functional.
6. Connect the 25-pin control cable from the system to RS-232C on the VCR.
7. Connect the VCR's power cord into the back of the VCR, and plug the other
end into an appropriate power source.
8. Turn on the VCR, and then turn on the ultrasound system.
Conguring Print Functions
In the setups, you can associate a set of printers with each of the print controls.
You cannot print to a printer unless it has been selected. A maximum of two
DICOM printers, two local printers, and one report printer can be selected
among the three lists. Both Print and Acquire can print to local and network
printers; Alt Print can print only to local printers; and Report can print only
to the local report printer. You can also change other printing parameters.
NOTE
During a study, Print/Network setups cannot be changed after you acquire an
image.
1. Press the Setup key.
111
iE33 User Manual
4535 616 23901
4
Preparing the System
To Next Page
Loading...