2. In the setups, click Print/Network.
3. Click the Device Selection tab, and then click Printer.
• To specify which printers receive images when you press Acquire on a
frozen image, select the printer from the Association to Acquire Key
while Frozen list.
• To associate the Print and Alt Print controls to a specific printer, select
Control Panel or Touch Screen in the menus under Association to
Control Panel Print Key of Touch Screen Alt Print.
4. To modify the printer settings, select the printer, click Edit, and do any of
the following:
• To set the number of copies to be printed each time you use a print
control, select the current setting and enter a number for Number of
Copies.
• Make additional configuration changes, such as Film Orientation or Film
Display Format, as needed. If necessary, to revert to the default settings
stored in the system, click Reset Defaults.
NOTE
The Advanced control is for configuring the printer properties, which are
unique to each type and model of printer.
5. To apply and save your changes, click OK.
6. Click the Printer/Capture tab.
7. Do any the following:
• To change the area printed, make selections for Acquire Key while
Frozen and Control Panel Print Key for Print Format.
• To send report data to a computer or workstation, select To Report
Server for Send Report. Otherwise, select To Report Printer.
8. To exit the setups, click Done.
iE33 User Manual
112
4535 616 23901
Preparing the System
4
To Next Page
Loading...