Wireless Network Configuration
Installation 2-3
Wireless Network Configuration
MX40 865350 and 865351 (Smart-hopping)
For the Smart-hopping MX40s (865350, 865351), wireless network configuration
happens as a part of the equipment label assignment procedure. The MX40s are
shipped from the factory with an Equipment Label of "NEW_DEVICE" and an RF
Access Code of "0". This allows basic wireless connectivity to any Smart-hopping
Access Point. After the MX40 has basic connectivity to the Smart-hopping network,
the "Label Assignment" procedure can be performed at the Information Center. The
"Label Assignment" procedure configures the RF Access Code and Equipment
Label into the MX40 without the need for any additional tools.
MX40 865352 (802.11 a/b/g/n)
For the 802.11 a/b/g/n MX40s (865352), wireless network configuration must be
completed before the equipment label assignment procedure can be performed.
The WLAN configuration is done using the IntelliVue Support Tool – Mark2. See
Chapter 9 of this document and also the IntelliVue Support Tool Instructions for
Use for details.
To Next Page
Loading...
