Philips IntelliVue MX40 - Waveform Settings at the MX40

Monitoring Mode
Operating Modes 4-15
Setting Description
Paced Mode
(Set at IIC Release N or IIC iX. View only.)
On, Off, Unconfirmed (IIC iX only)
Adjust Size Set ECG gain to x1/2, x1, x2, x4
Arrhythmia Initiate an Arrhythmia Relearn; View Arrhythmia
Alarm Limits; Turn Arrhythmia Annotation On/Off
(local control on device only.)
Lead Placement Set EASI, Standard
ECG Set ECG On/Off
New Lead Setup When IntelliVue Patient Monitor lead sets are in
use, select 3-wire, or 5-wire.
Va Lead Shows position of Va, or Ca, electrodes. Choices
are V1-V9, v3R, V4R, V5R. Configured at IIC/IIC
iX.
Vb Lead Shows position of Vb, or Cb, electrodes. Choices
are V1-V9, v3R, V4R, V5R. Configured at IIC/IIC
iX.
Change Numeric
Selects parameter numeric to display in place of
current HR numeric.
Note — ECG monitoring is turned off when the SpO2 only adapter
accessory is attached to the MX40. When a battery change occurs, ECG
monitoring resumes if the SpO2 only adapter accessory is no longer
attached.
Waveform Settings at the MX40
Setting Description
Wave 1 Primary, Secondary, I, II, III, aVR, aVL, aVF, V1-
V9, MCL, V3R, V4R, V5R, Pleth (if SpO
2
is
available), Resp (if Resp is available). Available
waveforms are based on patient cable type.
Primary wave is the default. If Primary or
Secondary are selected, then the waveform
displayed is the waveform configured as primary
or secondary for arrhythmia analysis at the
Information Center.
Wave 2 Primary, Secondary, I,II, III, aVR, aVL, aVF, V1-
V9, MCL, V3R, V4R, V5R, Pleth (if SpO
2
is
available), Resp (if Resp is available). Available
waveforms are based on patient cable type.
Secondary wave is the default. If Primary or
Secondary are selected, then the waveform
displayed is the waveform configured as primary
or secondary for arrhythmia analysis at the
Information Center..