Configuration Mode
4-30 Operating Modes
Configuration Mode
For information on configuration settings that are entered at the MX40, see
the IntelliVue MX40 C.01 Configuration Guide contained on the MX40
Documentation CD, p/n 4535 647 51811. For information on configuration
settings that are entered at the Information Center, see the Patient
Information Center iX Clinical Configuration Guide, Release C.03 contained on
the MX40 Documentation CD, p/n 4535 647 51811.
Configuration Mode is password protected. The password to enter is
"71034". This password may be modified. See Change Password on pg. 4-28.
Clinical Configuration
The table below lists the settings that are configured using the
Configuration menu:
Setting Description MX40 with IIC N
MX40 with IIC
L/M
MX40 with IIC iX
Touch Tone
Volume:
Audio feedback for
button touch events.
Mute (0) or allow sound
feedback
0 -10
4
0-10
4
0-10
4
Default Screen: Screen displayed after
power on
1 wave - P(ortrait)
2 waves - P(ortrait)
2 waves - L(andscape)
Chest Diagram
All numerics
1 wave - P(ortrait)
Chest Diagram
The default setting at
IIC iX overrides the
MX40 Default Screen
setting. Additional 6
numerics (no waves)
screen available, but
cannot be configured
as Default Screen.
Screen Color: The color of the Standby
screen can be changed.
This can be used to
distinguish devices
between different units,
e.g. Blue for CCU,
Green for ED
Blue, Gray, Green,
Pink, Purple, Yellow
Note — Blue, Gray,
and Green apply to
both Startup and
Standby screens.
Pink, Purple and
Yellow apply to
Standby screen only.
Blue, Gray, Green,
Pink, Purple, Yellow
< B.04
Blue, Gray, Green,
Pink*, Purple*, Yellow*
> B.05
Blue, Green, Purple,
Orange*, Aqua
(* only display in
Standby Mode)
ECG Cable
Color:
These are the colors that
will be displayed on the
chest diagram if a
patient cable type
cannot be determined.
AAMI, IEC AAMI, IEC AAMI, IEC
To Next Page
Loading...
