Service Mode
Operating Modes 4-33
Service Mode
This section describes the menus and settings accessed from the Service
Operating Mode. Service Mode is password protected. The password to
enter is "1345". This password may be modified. See below.
Change Password
The Change Password menu allows you to set new passwords on the
MX40 for access to Configuration Mode, Service Mode and Demo Mode.
Passwords must have a minimum of three numerical characters and a
maximum of five numerical characters.
1. Enter current password.
2. Enter new password.
3. Re-enter new password.
Setup Network
The Setup Network menu allows you to set the RF Access Code for the
MX40.
Revisions
The Revisions menu displays the Device Info menu:
• Service #: This is the Service Identification Number located on the back
label and used to identify the device.
• S/N: This is the Hardware Serial Number for the device located on the
back label and used to identify the device.
• SW Service #: This is the Service Identification Number for the software
version on the device. It can be found on the Software License
Certificate that shipped with the Device.
• SW SN: This is the Software License Number. It can be found on the
Software License Certificate that shipped with the device.
Note — Customers should save the Software License Certificate for
future reference.
• Appl SW: This is the revision of the software installed and running on
the MX40.
• HW Rev: This is the Revision Number for the device hardware.
To Next Page
Loading...
