Philips IntelliVue MX40 - Cleaning Materials for the MX40

Cleaning
5-4 Maintenance
7. Remove cleaner residue by wiping the MX40, exterior surfaces of the
patient cables, rechargeable battery, and battery tray with a lint-free
cloth modestly dampened with distilled water or isopropyl alcohol.
8. Allow to air-dry, or dry with a non-lint producing cloth.
9. Store the MX40 until ready to re-use. Do not insert rechargeable or
disposable batteries until ready for use.
Cautions
Never immerse or soak the MX40, the patient cable, the batter adapter tray,
or the rechargeable battery in any liquid solution for cleaning or
disinfecting. Damage may result.
Use of cleaning/disinfecting agents other than isopropyl alcohol inside the
patient cable connector and battery adapter tray can result in chemical
residue build-up and damage to the contacts. Connecting the patient cable
to the MX40 while there is still moisture from the cleaning/disinfecting
agents other than isopropyl alcohol present, and then inserting the
rechargeable battery or battery adapter tray and batteries into the MX40 can
result in corrosion of the MX40 pins and patient cable contacts.
Use of brushes with stiff and/or wire bristles on any part or component of
the MX40 may cause damage.
Cleaning Materials for the MX40
Cautions
• Use of abrasive cleaning materials, or disinfectants or cleaning agents
not listed herein, on any part or component of the MX40 may damage
the components.
• Sharp or pointed instruments should not be used to remove soil from
recessed areas on the MX40.
Note —The cleaners listed in the following table have been tested and
approved by Philips as of the print date of this document.
Note —The listed cleaners are also suitable for cleaning the outside of the
patient cable, the rechargeable battery, and the outside surface of the
battery adapter tray.