Understanding Settings
Basic Operation 4-13
When IntelliVue Patient Monitor lead sets are in
use, select 3-wire, or 5-wire.
Shows position of Va, or C1, electrodes. Choices
are V1-V9, v3R, V4R, V5R.
Shows position of Vb, or C2, electrodes. Choices
are V1-V9, v3R, V4R, V5R.
Selects parameter numeric to display in place of
current HR numeric.
Waveform Settings at the MX40
Primary, Secondary, I, II, III, aVR, aVL, aVF,
V1-V9, MCL, V3R, V4R, V5R. Available
waveforms are based on patient cable type. Lead
II is the default. If Primary or Secondary are
selected, then the waveform displayed is the
waveform configured as primary or secondary for
arrhythmia analysis.
Primary, Secondary, I,II, III, aVR, aVL, aVF,
V1-V9, MCL, V3R, V4R, V5R, Pleth (if SpO
2
is
available), Resp (if Resp is available). Available
waveforms are based on patient cable type. Lead
V is the default. If Primary or Secondary are
selected, then the waveform displayed is the
waveform configured as primary or secondary for
arrhythmia analysis.
Primary or secondary waveform configuration changes made at the
Information Center change the MX40.
To Next Page
Loading...
