27 Using the Drug Calculator
340
2
Select the correct patient category for your patient.
If you have a neonatal or pediatric patient, the
Rule Of 6 choice may be available. Select if required.
3 Enter the patient weight, if necessary.
If available, the patient weight from the
Patient Demographics window is entered automatically in
the
Drug Calculator window. To change the patient weight, select the Weight key then use the on-
screen keypad to enter the correct value. This will not change the patient weight stored in the
patient demographic information. Select the weight unit shown to change between lb and kg.
4 When a specific drug is selected, the initial values for Dose, Amount and Volume are the
configured Start values for this drug. The
Rate is then calculated. If other values are required you
can calculate any value by entering the remaining three values as described in “Performing
Calculations for a Non-Specific Drug” on page 339.
The column on the right of the window shows either drug dose or dosage rate, whichever is the
calculated value. The current calculated value is shown on a scale with the recommended range in
green. If the current calculated value lies outside the recommended range it is shown in red.
If you have changed values in the Drug Calculator and you want to revert to the configured values,
select
Reset Values key at any time.
Charting Infusion Progress
The Drip Table shows you at a glance how much of the infusion has been administered to your patient
and how much time is left.
•To see the
Drip Table, in the Drug Calculator window, select the Drip Table pop-up key.
If the Drip Time exceeds 24 hours, the Drip Time timestamp shows - - :- - : - - .
To Next Page
Loading...