58
8.4.12. BENT PAPER S (L) Board and BENT PAPER R (L) Board
1. Remove the Imprinter Door. (See 8.3.1.)
2. Remove the Top Cover. (See 8.4.8.)
3. Remove the spring to release the Lock Assembly from the
scanner.
4. Remove the Lock Assembly.
5. Remove the screw and disconnect the connector from the
BENT RELAY Board.
6. Pull out the BENT PAPER S (L) Board and the BENT
PAPER R (L) Board.
7. Disconnect the connector to the BENT PAPER S (L) Board.
8. Disconnect the connector, and then remove the 2 screws on
the BENT PAPER R (L) Board.
To Next Page
Loading...
