Philips L Series - Installation Steps; 90° Angle Installation Final Tightening; 180° Angle Installation Gauge Use

41BDL7324L
9
Step 7.
(for 90° angle installation)
Tighten the screw bolts (
1
). Repeat the above steps until all cabinets are mounted onto the bracket. Adjust the atness of the
LED display (if necessary). Firmly tighten the screw bolts to secure the cabinets to the mounting bracket (
2
).
2
1
Step 8. (for 180° angle installation)
For 180° angle installation, appropriate clearance between two cabinets must be considered. Follow the installation steps
below.
Tighten the screw bolts (
1
). Repeat the above steps until all cabinets are mounted onto the bracket.
Use the feeler gauges to ensure accurate gap is reserved between the cascaded cabinets. Insert 2 pieces of 1mm feeler gauge
into the gap between two parts as illustrated below (
2
).
The feeler gauges are not provided with the product.
Adjust the atness of the LED display (if necessary). Firmly tighten the screw bolts to secure the cabinets to the mounting
bracket (
3
).
After installation is complete, pull out the feeler gauges.
0.5 mm
2
1mm
1
3
For installation of two types of cabinets with dierent side angles (e.g., xxBDL7324L and xxBDL7224L), use the 0.5mm feeler
gauge to keep clearance between two cabinets.