19
English
4 Press the device firmly onto your skin and hold it in place. The 'READY to
flash' light should light up white.
5 Press the flash button to release a flash on your skin. The flash treats the
skin in that spot.
The device makes a soft popping sound. The flash gives you a warm
sensation.
After each flash, it takes up to 3.5 seconds until the device is ready to
flash again. You can release a flash when the 'READY to flash' light lights
up white.
6 Move the device to the next spot, close to, but not overlapping the
previous spot. Make sure that you flash the same area only once.
7 Continue until you have treated the full area. There are two treatment
modes (see 'Two treatment modes: Stamp & Flash and Slide & Flash').
8 Turn off the device when you finished the treatment.
9 Remove hair before every next treatment, as long as hair is still visible.
Note: Do not try the device on difficult or sensitive areas (ankle and bony
area).
D Clean & store after treatment
1 Unplug the device from the power outlet if you have used it with the
power adapter.
2 Let the device cool down.
3 Moisten the soft cloth supplied with a few drops of water.
To Next Page
Loading...
